The Oregon 2 light clear glazed door is classically designed with American white oak veneer and gives you the best of both worlds: two glazed panels and two solid. With a 30 minute fire rating, this door will allow you to have that extra peace of mind. High Quality American... Read More
The Oregon 2 light clear glazed door is classically designed with American white oak veneer and gives you the best of both worlds: two glazed panels and two solid. With a 30 minute fire rating, this door will allow you to have that extra peace of mind.
Width: 686mm 27”
Height: 1981mm 78”
Thickness: 44mm
Width: 762mm 30”
Height: 1981mm 78”
Thickness: 44mm
Width: 838mm 33”
Height: 1981mm 78”
Thickness: 44mm
Material composition: Solid core doors are solid from front to back. Made from wood by-products, solid core doors are dense, heavy and withstand more punishment than hollow core doors. The typical solid core door is a mixture of wood particles glued together with heat, resins and hydraulic pressure to produce a uniform, consistent product. Moulded wood fibre face with softwood stiles and rails Heavyweight flax board core.
Installation: Internal doors should not be installed in areas with recent plastered, screeded or wet sites. All of our doors including those pre-finished, should not be exposed to inappropriate damp site conditions.
Trim: Each door is supplied with a 5mm trim option on all four edges. There is no trim allowance on the top edge for fire doors within this range. Bi-fold doors are made undersized to allow for operation - please note they should not be trimmed.
Storage: When receiving door it should be laid flat fully supported off the floor in a dry and fully ventilated area with protective packaging intact. Doors supplied unfinished should be thoroughly sealed on all faces and edges prior to any installation work.
Finishers: It is essential that the door is completely finished on the two faces and all FOUR edges plus any cut-outs for locks, handles and hinges etc. Prior to finishing or sealing, lightly sand any handling marks. Usually 3 top coats are satisfactory but we strongly recommend you that you treat this door in accordance with the paint manufacturer’s instructions. A light sanding between coats will provide the best finish. Adequate drying time must be allowed between each coat. Failure to seal the doors accordingly will invalidate any claims.
There are no product downloads to show.
There are currently no questions for this product.
Products We Recommend
Product Enquiry Form
0% for 4 months
Learn more
Start right away with 4 months to pay
Enjoy 0% over 4 monthly instalments*
* Subject to status. Minimum spend required. T&Cs apply.
Sorry
It seems you are running an older version of Internet Explorer. Our site does not support these old browsers as they do not house the technology that allows our site to be safe and secure.
If you wish to access our site please either upgrade your browser or download an alternative.
