The Newbridge white primed vertical etch glazed interior door offers both contemporary and tradional design. This is a firm favourite amongst homeowners with its wide range of finishes and sizes avaiable. Cottage style 2 panel vertical design Smooth faced design Glazed to... Read More
The Newbridge white primed vertical etch glazed interior door offers both contemporary and tradional design. This is a firm favourite amongst homeowners with its wide range of finishes and sizes avaiable.
Width: 762mm
Height: 1981mm
Thickness: 35mm
Material composition: Solid core doors are solid from front to back. Made from wood byproducts, solid core doors are dense, heavy and withstand more punishment than hollow core doors. The typical solid core door is a mixture of wood particles glued together with heat, resins and hydraulic pressure to produce a uniform, consistent product.
Installation: Internal doors should not be installed in areas with recent plastered, screeded or wet sites. All of our doors including those pre-finished, should not be exposed to inappropriate damp site conditions.
Trimming: There is a 4mm trim option along the two long edges, 6mm on the bottom edge and no trim allowance on the top edge. All doors are supplied with unfinished edges.
Storage: When receiving door, it should be laid flat fully supported off the floor in a dry and fully ventilated area with protective packaging intact. Doors supplied unfinished should be thoroughly sealed on all faces and edges prior to any installation work.
Finishers: Be sure to select a finisher with a lasting seal between component parts. Please avoid water-based finishers, using only good quality solvent-based finishers. Danish oil is not suitable for use on any of our doors. It is essential that the door is completely finished on the two faces and all four edges plus any cut-outs for locks, handles and hinges etc. Prior to finishing or sealing, lightly sand any handling marks. Usually 3 top coats are satisfactory, but we strongly recommend you that you treat this door in accordance with the paint manufacturer’s instructions. A light sanding between coats will provide the best finish. Adequate drying time must be allowed between each coat. Failure to seal the doors accordingly will invalidate any claims.
There are no product downloads to show.
There are currently no questions for this product.
Products We Recommend
Product Enquiry Form
0% for 4 months
Learn more
Start right away with 4 months to pay
Enjoy 0% over 4 monthly instalments*
* Subject to status. Minimum spend required. T&Cs apply.
Sorry
It seems you are running an older version of Internet Explorer. Our site does not support these old browsers as they do not house the technology that allows our site to be safe and secure.
If you wish to access our site please either upgrade your browser or download an alternative.
